Direct Acting Two Way Plastic Water Drain Solenoid Valve 24v For Water Filter

Direct Acting Two Way Plastic Water Drain Solenoid Valve 24v For Water Filter

RO water solenoid valve is used inReverse Osmosis System.The valve is assembled with high quality copper wire solenoid coil, and no leaking armature tube assembly. The valve body is made of Plastic (PP,POM,Nylon). All water Purifier products available in RO are made of food grade plastic for retaining the purity of the soft water .

Reverse Osmosis systems

A simple reverse osmosis system consists of a high-pressure pump which increases the pressure of the feed water with salts, ions or impurities. This forces the water across the semi permeable RO (Reverse Osmosis) membrane, leaving behind all the dissolved salts. The required pressure is directly proportional to the salt concentration of the inlet water. The higher the concentration, the higher pressure is required to overcome the osmotic pressure.

The RO membrane lets the cleaner water through and this is called permeate water. The salts and other contaminants which are stopped by the membrane come out as a reject stream. This can be drained out or recycled if possible through the RO system to save water.

The RO systems remove up to 99% of dissolved salts (ions), particles, pathogens and bacteria from feed water.

Nylon Material:
Polyamide is mainly used for synthetic fibers, its most prominent advantage is that its wear resistance is higher than all other fibers.

This type of product has a wide range of uses. It is a good material that replaces steel, iron, copper and other metals with plastic, and is an important engineering plastic; cast nylon widely replaces wear-resistant parts of mechanical equipment, and replaces copper and alloys as wear-resistant parts of equipment . Suitable for making wear-resistant parts, transmission structural parts, household appliances parts, automobile manufacturing parts, screw preventive mechanical parts, chemical machinery parts, and chemical equipment. Such as turbines, gears, bearings, impellers, cranks, dashboards, drive shafts, valves, blades, screw rods, high-pressure washers, screws, nuts, sealing rings, shuttles, sleeves, bushing connectors, etc.

Main Dimension of RO Solenoid Water Valve:

Technical data:

Brando Factory Production of Solenoid Valves:

Feature:

The solenoid valve is usually used for RO purifier water treatment, with DC24V DC36V voltage option. The valve is assembled with high quality copper wire solenoid coil, and no leaking armature tube assembly. The valve body is made of POM, delrin material, with good performance of strength. And also we assemble special designed o-ring to ensure no leaking while valve working.

Turn on water when system start;and cut off water when system stop.
Domestic RO based water system uses water solenoid valve to control feed and in membrane flushing. Due to lower inlet pressure, pilot operated valves cannot give adequate flow. All water Purifier products available in RO are made of food grade plastic for retaining the purity of the soft water .

1.Solenoid valves are the most frequently used control elements in fluidics.
2.Their tasks are to shut off, release, dose, distribute or mix fluids.
3.They are found in many application areas.
4.Solenoids offer fast and safe switching, high reliability, long service life, good medium compatibility of the materials used, low control power and compact design.

Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing

Welcome to your any question and inquiry!

Reverse Osmosis Solenoid Valve

NC Plastic Solenoid Valve

24v Water Drain Solenoid Valve

Direct Acting Two Way Plastic Water Drain Solenoid Valve 24v For Water Filter Images